Table of Contents
Advertisement
Carefully read p. 55 (MAINTENANCE).
WARNING
Wait until the engine and the exhaust si-
lencer have completely cooled down.
N
Position the vehicle on the side stand on
firm and level ground.
N
Rotate the six rapid fastening screws (1)
by giving them 1/4 turn anticlockwise.
CAUTION
Handle the plastic and painted compo-
nents with care and avoid scraping or
damaging them.
N
Remove the side fairing (2).
NOTE
Repeat these operations to re-
move the other side fairing.
Carefully read p. 55 (MAINTENANCE).
NOTE
To remove the lower fairing, it is
necessary to use the appropriate rear sup-
port stand
.
N
Position the vehicle on the appropriate
rear support stand, see p. 62 (POSI-
TIONING THE VEHICLE ON THE REAR
SUPPORT STAND
).
N
Remove the two side fairings, see beside
(REMOVING THE SIDE FAIRINGS).
N
Unscrew and remove the two front
screws (3).
#
N
Unscrew and remove the rear screw
(4).
N
Unscrew and remove the two screws (5)
of the rear right profile (6) (inside the ex-
haust silencer).
CAUTION
Handle the plastic and painted compo-
nents with care and avoid scraping or
damaging them.
N
Let the side stand down.
N
Withdraw the two pipes (7-8) from the
hole provided on the fairing.
N
Remove the entire lower fairing (9) by
lowering it and with small movements try
to find the best position to withdraw it
from the side stand.
NOTE
Upon reassembly, introduce the
two pipes (7-8) in the hole provided on the
fairing.
N
Take the rear right profile (6).
NOTE
Upon reassembly, the upper part
of the profile (6) must be fitted between the
lower fairing (9) and the support plate.
use and maintenance RSV mille - RSV mille R
71
Hide quick links:
Advertisement
Table of Contents
