PARKING LIGHT BULB
Remove the front part of the fairing, see
p. 79 (REMOVING THE FRONT PART
OF THE FAIRING).
CAUTION
To extract the bulb socket, do not pull
the electric wires.
Grasp the parking light bulb socket (8),
pull it and remove it from its seat.
Withdraw the bulb (2) and replace it with
one of the same type.
NOTE
Make sure that the bulb is cor-
rectly inserted in the bulb socket.
9
10
LOW BEAM BULB
NOTE
Extract the connectors one by
one, in such a way as to avoid positioning
them wrongly upon reassembly.
If it is necessary to remove all the connec-
tors at the same time, mark them and
make sure that you position them correctly
upon reassembly.
Remove the front part of the fairing, see
p. 79 (REMOVING THE FRONT PART
OF THE FAIRING).
Move the protection element (9) with
your hands.
CAUTION
To extract the bulb electric connector,
do not pull its wires.
Grasp the bulb electric connector (10),
pull it and disconnect it from the bulb.
A
11
12
Release the two ends of the check
spring (11) positioned on the bulb socket
(12).
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
making the respective positioning seats (A)
coincide.
Correctly install a new bulb of the same
type.
Upon reassembly:
NOTE
Put back the protection element
(9) with the cable passage facing down-
wards.
use and maintenance RSV mille - RSV mille R
A
103