Firmware Screen; Table 13-7 Diagnostic Dsl Line - ZyXEL Communications PRESTIGE 650H User Manual

Prestige 650 Series User's Guide
The following table describes the labels in this screen.
LABEL
Reset ADSL Click this button to reinitialize the ADSL line. The large text box above then displays the
Line progress and results of this operation, for example:
"Start to reset ADSL
Loading ADSL modem F/W...
Reset ADSL Line Successfully!"
ATM Status Click this button to view ATM status.
ATM Loopback Click this button to start the ATM loopback test. Make sure you have configured at least
Test one PVC with proper VPIs/VCIs before you begin this test. The Prestige sends an OAM
F5 packet to the DSLAM/ATM switch and then returns it (loops it back) to the Prestige.
The ATM loopback test is useful for troubleshooting problems with the DSLAM and ATM
network.
Upstream Noise Click this button to display the upstream noise margin.
Margin
Downstream Click this button to display the downstream noise margin.
Noise Margin
Back Click this button to go back to the main Diagnostic screen.

13.6 Firmware Screen

Find firmware at www.zyxel.com
extension, e.g., "Prestige.bin". The upload process uses FTP (File Transfer Protocol) and may take up to two
minutes. After a successful upload, the system will reboot. See the Firmware and Configuration File
Maintenance chapter in the parts that document the SMT for upgrading firmware using FTP/TFTP
commands.
Only use firmware for your Prestige's specific model. Refer to the label on the
Click Firmware to open the following screen. Follow the instructions in this screen to upload firmware to
your Prestige.
13-12

Table 13-7 Diagnostic DSL Line

in a file that (usually) uses the system model name with a "*.bin"
bottom of your Prestige.
DESCRIPTION
Maintenance