ZyXEL Communications PRESTIGE 650H User Manual page 186

Prestige 650 Series User's Guide
FIELD
Multiplexing
VPI #
VCI #
ATM QoS Type
Peak Cell Rate
(PCR)
Sustain Cell Rate
(SCR)= 0
Maximum Burst Size
(MBS)= 0
My Login
My Password
ENET ENCAP
Gateway
Idle Timeout
IP Address
Assignment
IP Address
18-6
Table 18-2 Menu 4 Internet Access Setup
SPACE BAR
Press [ ] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based.
Enter the Virtual Path Identifier (VPI) assigned to you.
Enter the Virtual Channel Identifier (VCI) assigned to you.
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
This is the maximum rate at which the sender can send cells.
Type the PCR.
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR.
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that your
ISP gives you. If you are using PPPoE encapsulation, then this
field must be of the form
identifies your PPPoE service name.
Enter the password associated with the login name above.
Enter the gateway IP address supplied by your ISP when you
are using ENET ENCAP encapsulation.
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session.
SPACE BAR
Press [ ] to select Static or Dynamic address
assignment.
Enter the IP address supplied by your ISP if applicable.
DESCRIPTION
user@domain where domain
EXAMPLE
LLC-based
8
35
UBR
0
0
0
N/A
N/A
N/A
0
Dynamic
N/A
Internet Access