Protocol Dependent Ethernet Setup; Tcp/Ip Ethernet Setup And Dhcp; Figure 16-3 Menu 3.2 Tcp/Ip And Dhcp Ethernet Setup - ZyXEL Communications PRESTIGE 650H User Manual

Prestige 650 Series User's Guide

16.2 Protocol Dependent Ethernet Setup

Depending on the protocols for your applications, you need to configure the respective Ethernet Setup, as
outlined below.
For TCP/IP Ethernet setup refer to the Internet Access Application chapter.
For bridging Ethernet setup refer to the Bridging Setup chapter.

16.3 TCP/IP Ethernet Setup and DHCP

Use menu 3.2 to configure your Prestige for TCP/IP.
To edit menu 3.2, enter 3 from the main menu to display Menu 3 — Ethernet Setup. When menu 3
appears, press 2 and press [ENTER] to display Menu 3.2 — TCP/IP and DHCP Ethernet Setup, as
:
shown next
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP Setup:
TCP/IP Setup:
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Follow the instructions in the following table on how to configure the DHCP fields.
16-2
DHCP= Server
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 32
Primary DNS Server= 0.0.0.0
Secondary DNS Server= 0.0.0.0
Remote DHCP Server= N/A
IP Address= 192.68.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
IP Policies=
Edit IP Alias= No

Figure 16-3 Menu 3.2 TCP/IP and DHCP Ethernet Setup

First address in
the IP pool
Size of the IP
Pool
IP addresses of
the DNS
servers
This is the IP
address of the
Prestige
LAN Setup