Remote Management And Nat; System Timeout - ZyXEL Communications PRESTIGE 650H User Manual

29.2.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the Prestige will disconnect the session immediately.
4. There is already another remote management session of the same type (Telnet, FTP or Web)
running. You may only have one remote management session of the same type running at one
time.
5. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.

29.3 Remote Management and NAT

When NAT is enabled:
Use the Prestige's WAN IP address when configuring from the WAN.
Use the Prestige's LAN IP address when configuring from the LAN.

29.4 System Timeout

There is a system timeout of five minutes (300 seconds) for Telnet/web/FTP connections. Your Prestige
will automatically log you out if you do nothing in this timeout period, except when it is continuously
updating the status in menu 24.1 or when sys stdio has been changed on the command line.
Remote Management
Prestige 650 Series User's Guide
29-3