Pioneer AVIC-N3 Operation Manual page 139

Symptom
The map continually reorients itself.
Tracking marks are not displayed.
The daylight display is used even
when the vehicle lights are on.
The system will not switch on or will
not operate.
The display is very dim.
There is no voice guidance or the vol-
ume is low.
Slope is not displayed on the
Vehicle Dynamics screen.
Inclination does not move on the 3D
Calibration screen.
When the screen is frozen...
Park your vehicle at a safe place, and cut off the engine. Turn the ignition key back to "Acc off". Then
start the engine again, and turn the power to the navigation system back on. If this does not solve the
problem, press the RESET button on the navigation system.
Cause
Your vehicle is operating in Simple
hybrid mode.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Indication of the position of your vehi-
cle is misaligned after a U-turn or
reversing.
The traveling direction is always set
to Heading Up.
The "Tracking Display" is turned
off.
Daytime is selected to "Day/Night
Display".
The orange/white lead is not con-
nected.
Installation or connection has been
carried out incorrectly.
The vehicle's light is turned ON, and
"Nighttime" is selected on "Day/
Night Display".
The vehicle cabin temperature is
extremely low.
Picture quality adjustment of the dis-
play is not correct.
Ambient light sensor of the display is
hidden.
The volume setting is low or the
speaker lead is disconnected.
The speed pulse lead is not con-
nected.
Action (See)
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor memory ("Learning Status").
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to "Installation Man-
ual".)
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The navigation sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
Touch on the screen and change
the map display.
Check the "Tracking Display" set-
tings (➞ Page 70) and make sure
"Always" or "This Trip" is selected.
Check the "Day/Night Display" set-
ting (➞ Page 70) and make sure
"Nighttime" is selected.
Check the connection.
Check with your dealer.
Read about the "Day/Night Dis-
play" setting (➞ Page 70) and, if
desired, select "Daytime".
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Refer to "Hardware Manual" to adjust
the picture quality.
Set the ambient light sensor not to
be hidden.
Check the volume setting on the dis-
play or turn the volume up according
to "Volume" (➞ Page 67) and/or turn
up the volume on the display.
Connect the speed pulse lead.
137