Panasonic WV-AS65 Operating Instructions Manual page 58

Step 7
Perform the VMD area setup and detection parameter
setup.
VMD area setup
Set the motion detection areas by dragging the cur-
sor. Up to 4 areas (A, B, C, D) can be set for the
detection areas.
A: White, B: Blue, C: Green, D: Red
To delete a detection area, click the [DELETE
AREA(D)] button after selecting a detection area by
checking the box of the desired area to be deleted.
"Sensitivity(S)"
Select the sensitivity for each VMD area from the
following: Click the
for the selected area from the following.
"HIGH": High sensitivity
"MID": Middle sensitivity
"LOW": Low sensitivity
"OFF": Ignores motion in the selected area
"VMD mode" setup
Perform the settings for the detection mode. It is
possible to set how motion is detected in the
motion detection area by performing the settings
for each detection mode.
Select the desired detection mode and perform the
settings by checking/not checking the radio but-
tons.
• <ANY AREA>
An event action will be performed according to
the settings when "motion" is detected in any of
the set motion detection areas.
• <VECTOR>
Click the button to create a series of VMD
areas in the desired order. Click the
to select a moving duration for an object from
the following.
--/5s/10s/20s/30s/40s/50s/1min
<DURATION>
Click the button to select a detection time
for each area.
0s/5s/10s/20s/30s/40s/50s/1min
58
button to select sensitivity
button
Note:
Refer to the Network Operating Instructions (PDF)
of the recorder for further information about the
VMD search.
Step 8
Click the [OK] button to save the settings for the VMD
areas.
The VMD setup window displayed on the search win-
dow will be closed.
Step 9
Click the [Search(S)...] button.
The search status window will be displayed.
Note:
When the VMD area is not yet set, a message win-
dow will be displayed.
Go to step 4 to set the VMD area.
Step 10
Click the [Search list view(S)] button.
The search result list window will be displayed.
Refer to page 61 for descriptions of how to operate on
the search result list window.