Launch Creader Professional MOT III Manual page 36

LAUNCH
1. To reset the steering angle, first find the relative zero point position for the car
to drive in straight line. Taking this position as reference, the ECU can
calculate the accurate angle for left and right steering.
2. After replacing the steering angle position sensor, replacing steering
mechanical parts (such as steering gearbox, steering column, end tie rod,
steering knuckle), performing four-wheel alignment, or recovering car body,
you must reset the steering angle.
Sunroof Initialization
This function can set the sunroof lock off, closed when it rains, sliding / tilting
sunroof memory function, temperature threshold outside the car etc.
Suspension Calibration
1. This function can adjust the height of the body.
2. When replacing the body height sensor in the air suspension system, or
control module or when the vehicle level is incorrect, you need to perform this
function to adjust the body height sensor for level calibration.
Tire Pressure Monitor System Reset
This function allows you to quickly look up the tire sensor IDs from the vehicle‟s
ECU, as well as to perform TPMS replacement and sensor test.
1. After the tire pressure MIL turns on and maintenance is performed, the tire
pressure resetting function must be performed to reset tire pressure and turn
off the tire pressure MIL.
2. Tire pressure resetting must be performed after maintenance is performed in
the following cases: tire pressure is too low, tire leaks, tire pressure monitoring
device is replaced or installed, tire is replaced, tire pressure sensor is
damaged, and tire is replaced for the car with tire pressure monitoring function.
Creader Professional MOT III English User Manual
35