Peak Hold, Valley Hold, And Average - RayTek Thermalert GP Series Operator's Manual

1.888.610.7664
2.4.7

Peak Hold, Valley Hold, and Average

The Peak Hold,Valley Hold, and Average times are factory set at 0 seconds
and are not activated. If you don't need to use these signal processing func-
tions, no adjustments are necessary.
Note: Only one signal processing setting can be active at a time.
To set and activate, complete the following steps:
1. Press and hold the button and press the
both. The Peak Hold display appears (Figure 15).
O
N
L
Figure 15: Peak Hold Display
2. Press the button again and the display shows the current Peak Hold
value in seconds.
3. Set the display by using the and
off Peak Hold.
4. Press the button again and the Valley Hold display (Figure 16)
appears.
Thermalert GP Series Operator's Manual
www.calcert.com
15
10 20
5 25
0 30
button and release them
Thermalert GP
C
F
buttons. Note that "000" turns
21
sales@calcert.com