Novation ReMOTE SL User Manual page 81

17 SAVING AND NAMING TEMPLATES
Before you perform a save operation make sure that Memory Protect is set to 'OFF' in the Global menu (see section 11).
When you save a template, the following data is stored and will be recalled when you next select that template:
-All settings for each individual control, as set in Edit mode
-All settings in the Template menu
-All settings in the Template Keyboard Zones menu
-The last bank and program change values sent from the DATA/SELECT encoder
-The current keyboard octave setting
-The currently selected rows of controls
-The current value of each assignable control
To save a template press WRITE when in Play mode, Edit mode, the Template menu or the Template Keyboard Zones
menu. The ReMOTE SL displays will then look as follows:
If you want to cancel the save operation then press one of the other mode/menu buttons (PLAY, TEMPLATE, EDIT or
GLOBAL), which will take you to that mode or menu.
On the template save display you can set the template name, shown on the top line of the left-hand display. The template
name can be a maximum of 48 characters long. To enter a character first use the encoders or buttons in line with the
'<' and '>' symbols on the display to move the cursor to where you want to enter the character. Then use the buttons in
line with 'Upper', Lower' and 'Punctu' / 'Number' to select the type of character you want to enter (upper case, lower case,
punctuation or number). Note that repeated presses of the button below 'Punctu' / 'Number' will switch between 'Punctu'
and 'Number'. Finally use the encoder, pot or buttons in line with 'CHAR' to select the character you want to enter. If you
want to enter a space then select 'Punctu', as the first punctuation character is a blank space.
Once you have set the template name use the encoder or buttons in line with 'To Template' to select the template memory
location that you want to save the template to. To complete the save operation press WRITE once more.
17. 1 RESTORING TEMPLATES
If you edit a template and then accidentally select another template without remembering to save your edits, you can
restore the last edited template by pressing the DATA/SELECT encoder when in Edit mode, the Template menu or the
Template Keyboard Zones menu. The ReMOTE SL displays will then look as follows:
The name and number of the template that you last edited will be shown. Press WRITE to restore the template with the
edited settings. This template will automatically be selected and you can press WRITE again to save it using the template
save procedure.
81