Novation ReMOTE SL User Manual page 58

plus the following combinations of the above:
U1 M1
U2 M1
U1 M2
U2 M2
M1 M2
U1 M1 M2
U2 M1 M2
PotMode: This sets the pot response for all controls in all templates that have their individual response set to 'GLOBAL'.
See section 14.1 for further info on pot response.
DispTime (Display Timeout): This sets the length of time that temporarily displayed information e.g. keyboard octave
setting, remains on the ReMOTE SL displays. Set the value between 0 and 1260ms, or to 'PERM' (permanent).
KeepVals (Keep Values): This applies to standard (non-Automap) templates. If this is set to 'ON' then the ReMOTE SL
will automatically store the value of each control when you switch away from the currently selected template and restore
those values when you select that template again. If this is set to 'OFF' then the ReMOTE SL will only store control values
when you manually save the template.
Midi Clk (MIDI Clock): This setting defines the MIDI clock source. The options are:
AUTO: automatic sensing of a MIDI clock source, including the ReMOTE SL's internal clock
INTERNAL: the ReMOTE SL's internal clock
EXT-AUTO: automatic sensing of a MIDI clock source, excluding the ReMOTE SL's internal clock
USB1: MIDI clock received on USB port 1, from a computer
USB2: MIDI clock received on USB port 2, from a computer
MIDI-IN: MIDI clock received at the MIDI IN connector on the back of the ReMOTE SL
Page 3
U1 U2 M1
Template Change: It is possible to use program change messages to remotely select templates on the ReMOTE SL. The
first Template Change setting allows you to define which MIDI Channel the ReMOTE SL will respond to program change
messages on. This can be set from 1 to 16 or to 'ANY'. The second Template Change setting allows you to set which MIDI
ports the ReMOTE SL will respond to program change messages on, and can be set as follows:
OFF: The ReMOTE SL will not respond to program change messages
U1: The ReMOTE SL will respond to program change messages sent from a computer on USB port 1
U2: The ReMOTE SL will respond to program change messages sent from a computer on USB port 2
M1: The ReMOTE SL will respond to program change messages received at the MIDI IN port on the back of the unit.
BPMPorts IDPorts
U1 M1 M2 U1 M1 M2 U1 U1 M1 M2
HUI
ON
58