Positioning; Temporary Positioning; Positioning In The Planned Location - treesse Phantom BA06 Installation Manual

Transport and position
2

POSITIONING

TEMPORARY POSITIONING

The installation of the spa should be done im-
mediately upon receipt.
In any case, once unpacked, if it is necessary to
temporarily place it on a surface awaiting the installation,
it will be necessary to place level concrete slabs having
a minimum thickness of 1.9 in under the entire bottom
of the spa.
Since the temporary base may shift, it is recommended
to leave the spa in that position for the shortest pos-
sible time.

POSITIONING IN THE PLANNED LOCATION

In case of installation above ground (freestanding),
place the spa in the installation environment (outdoor or
indoor) and verify its perfect flatness, essential for proper
operation.
For a recessed installation, lower the spa into the pre-
pared space.
If it was not possible to provide a technical inspec-
tion port on all sides of the spa, a pneumatic lift
is available (OPTIONAL - to be requested from
the Manufacturer) in order to simplify future maintenance
operations. It is recommended to provide a removable
inspection hatch "A" positioned on the side where the
spa components and connections are situated.
After positioning the spa in its prepared space and after
having connected the lift, test it.
Do not leave the empty spa in DIRECT SUNLIGHT.
The surface temperature could rise above 176°F
resulting in serious damage, including cavitation
and the deformation of the surface and components.
Damage caused by direct exposure to sunlight is not
covered by the warranty.
In such conditions place a cover (fixed or mobile) to
protect the spa.
EN
Optional lift with removable inspection hatch "A" po-
sitioned on the side where the components of the spa
are situated.
10
Phantom
spa
80°C
176°F