Download Print this page
treesse ATC System Instructions For Use Manual

treesse ATC System Instructions For Use Manual

Hydromassage tubs

Advertisement

Quick Links

HYDROMASSAGE TUBS
ATC System
Instructions for use
2019

Advertisement

loading
Need help?

Need help?

Do you have a question about the ATC System and is the answer not in the manual?

Questions and answers

Summary of Contents for treesse ATC System

  • Page 1 HYDROMASSAGE TUBS ATC System Instructions for use 2019...
  • Page 3 Dear Customer, Thank you for choosing a Treesse product. Welcome to our world of total well-being. We would like to remind you that all our products are built with top quality materials and are carefully tested according to safety standards.
  • Page 4: Table Of Contents

    _INDEX FOREWORD PRODUCT OVERVIEW PRELIMINARY OPERATIONS GENERAL OPERATION RADIO REMOTE CONTROL - HOW TO USE DISINFECTION CLEANING AND MAINTENANCE...
  • Page 5: Foreword

    _FOREWORD THE OPERATION AND MAINTENANCE MANUAL This manual has been prepared to help you make the best use of your TREESSE product in complete safety, avoiding conditions that may void your warranty. This manual is of fundamental importance, therefore it must be carefully kept, for any future consultation.
  • Page 6 The company denies all liability for problems resulting from failure to install the latter. _ELECTRICAL SETUP Treesse hot tubs are built in compliance with European (EN 60 335-2-60) laws and are tested during manufacturing to ensure safety of both the installer and the user. The electrical setup must be made by a qualified electrician.
  • Page 7: Product Overview

    _PRODUCT OVERVIEW This device allows you to activate the tub functions in wireless mode by using the common radio waves. The kit consists of a radio remote control (A), a charging station (B) equipped with power cord, and a receiver (C) installed on the tub.
  • Page 8: Preliminary Operations

    _PRELIMINARY OPERATIONS Radio control states The remote control features the following operating modes: BLOCKED: this is the mode used to prevent the integrated battery from switching on and, therefore, consuming it, during transport to the final customer. The backlight of the keys is turned off.
  • Page 9: General Operation

    _GENERAL OPERATION ICONS LEGEND Function keys ON/OFF Whirlpool DISINFECTION (combined) ON/OFF Airlpool Keys Airpool Settings Keys active only in the presence of Spot or Chromotherapy ON/OFF the AUDIO controller, not included Chromotherapy Colour change Hidden key POWER LED signal This icon (volume) also displays Warning icons the charging status of the battery;...
  • Page 10: Radio Remote Control - How To Use

    _RADIO REMOTE CONTROL - HOW TO USE Key P1: With the power source connected and water level in the tub (5 cm above the level of the nozzles), pressing this button activates the Whirlpool function, the backlight of the icon switches from dimmed white to bright white.
  • Page 11 _RADIO REMOTE CONTROL - HOW TO USE Blowing The blowing after function (elimination of residual water from the pipes of the airpool) is enabled After only after the level sensor has detected the presence of water in the tub for at least 2 minutes. Will be activated automatically after the level sensor (5 cm over the nozzle) has not detected water for at least 12 minutes.
  • Page 12 _RADIO REMOTE CONTROL - HOW TO USE Key TN: The hidden key TN is placed to the left of the company’s logo. By pressing and holding it, the remote control will b switched off completely. You can restart it by pressing again the hidden key until the backlight of the icons is restored.
  • Page 13: Disinfection

    _DISINFECTION The disinfection function is an automatic procedure of cleaning of the entire water circuit of the tub, including the tanks. This function is enabled after every use of the tub or after prolonged periods of inactivity of the same DISINFECTANT On the tub, there is the cap of the tank for disinfection.
  • Page 14: Cleaning And Maintenance

    _CLEANING AND MAINTENANCE GENERAL SURFACE CLEANING Common cleaning products such as neutral liquid cleaners can be used for regular cleaning of surfaces. It is advisable to apply the product with a soft cloth, rinsing thoroughly with water. Do not use, under any circumstances, any anti-limescale product. Their alkaline composition may damage the surfaces - IT IS ABSOLUTELY FORBIDDEN TO USE ABRASIVE PRODUCTS...
  • Page 15 NOTES...