57 Configuration Change, Some Held Jobs Were Not Restored; 58 Too Many Bins Attached; 58 Too Many Disks Installed; 58 Too Many Flash Options Installed - Lexmark X792de User Manual

Troubleshooting

57 Configuration change, some held jobs were not restored

Something has changed in the printer to invalidate the held jobs. Possible changes include:
•
The printer firmware has been updated.
• Paper input options needed for the print job were removed.
•
The print job was created using data from a device in the USB port and the device is no longer in the USB port.
•
The printer hard disk contains print jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many bins attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional bins.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

58 Too many disks installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
282