57 Configuration Change, Held Jobs Were Not Restored; 58 Too Many Trays Attached; 58 Too Many Flash Options Installed; 59 Incompatible Tray <X - Lexmark 13C1104 - X 466dwe B/W Laser User Manual

Troubleshooting

57 Configuration change, held jobs were not restored

Since the time the jobs were stored on the printer hard disk something has changed in the printer to invalidate the
held jobs. Possible changes include:
•
The printer firmware has been updated.
•
Paper input, output, or duplex options needed for the print job were removed.
•
The print job was created using data from a device in the USB port and the device is no longer in the port.
• The printer hard disk contains jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.
59 Incompatible tray <x>
Try one or more of the following:
•
Remove the specified tray.
•
Touch Continue to clear the message and continue printing without using the specified tray.

61 Remove defective disk

Try one or more of the following:
•
Touch Continue to clear the message and continue printing.
•
Install a different printer hard disk before performing any operations that require a printer hard disk.
265