Korg Microkorg XL User Manual page 72

microKORG XL
Stereo In - Stereo Out
Left
High Damp
Delay
Trim
Feedback
Delay
Trim
High Damp
Right
LFO LFO Shape
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (DelayTime Tempo Sync) ...........................................[OFF, ON]
p. 70 "BPM SYNC (DelayTime Tempo Sync)"
TM RATIO ............................... [BPM SYNC OFF: 000.5...400.0% (OVER)/
BPM SYNC ON: 012.5...400.0% (OVER)]
p. 70 "TM RATIO"
L DELAY, R DELAY (L, R Delay Time) ................ [000...1400ms, 1/64... 1/1]
p. 70 "L DELAY, R DELAY (L, R Delay Time)"
FEEDBACK .......................................................................[000...127]
p. 71 "FEEDBACK"
MOD.DEPTH .....................................................................[000...127]
Sets the depth of modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
p. 66 "LFO SYNC (LFO Tempo Sync)"
LFO FREQ (LFO Frequency) ........................................ [0.01...100.0Hz]
Sets the LFO speed.
p. 66 "LFO FREQ (LFO Frequency)"
72
Dry / Wet
Pan
MOD Depth
Pan
Dry / Wet
LFO Spread
SYNC .NOTE (LFO Sync Note) ............................................. [8/1...1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob.
This parameter will be displayed and can be set if "LFO Sync" is On.
NOTE
p. 66 "SYNC.NOTE (LFO Sync Note)"
LFO WAVE (LFO Waveform)................ [SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects the LFO waveform.
p. 66 "LFO WAVE (LFO Waveform)"
LFO.SHAPE ......................................................................... [–63...+63]
p. 66 "LFO.SHAPE"
KEY SYNC (LFO Key Sync) ............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
p. 67 "KEY SYNC (LFO KeySync)"
INI.PHASE (LFO Init Phase) .................................................. [000...180°]
Sets the starting location of the waveform.
This parameter will be displayed and can be set if "KEY SYNC" is ON.
NOTE
p. 67 "INI.PHASE (LFO Init Phase)"
LFO SPRD (LFO Spread)....................................................[–180...+180°]
Sets the phase difference between the left and right channels.
HI DAMP ...........................................................................[000...100%]
Sets the damping amount in the high range.
TRIM................................................................................... [000...127]
Sets the input level.