Korg Microkorg XL User Manual page 71

FEEDBACK .......................................................................[000...127]
Sets the amount of feedback for the left and right channels.
The amount of feedback for the right channel is linked with the proportion of
the left and right delay times so that the decay times of the left and right
channels will stay the same.
HI DAMP ........................................................................... [000...100%]
Sets the damping amount in the high range.
TRIM ...................................................................................[000...127]
Sets the input level.
SPREAD ...............................................................................[000...127]
Sets the width of the stereo image of the effect sound.
The stereo image is widest with a value of 127, and the effect sound of both
channels is output from the center with a value of 0.
7. LCR.DELAY (L/C/R Delay)
This multitap delay outputs three Tap signals to the left, center, and right
respectively. You can also adjust the left and right spread of the delay
sound.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Trim
+
Trim
Right
DRY/WET ......................................................["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (DelayTime Tempo Sync) ...........................................[OFF, ON]
Specifies whether the delay time will be synchronized.
If this is On, the delay time will synchronize to the tempo or MIDI clock.
Dry / Wet
L Delay
Level
C Delay
Spread
Level
Feedback
R Delay
Level
Dry / Wet
TM RATIO ................................[BPM SYNC OFF: 000.5...400.0% (OVER)
/BPM SYNC ON: 012.5...400.0% (OVER)]
Sets each delay time as a proportion relative to the "L DELAY," "C DELAY,"
and "R DELAY" values.
p. 70 "TM RATIO"
L DELAY, C DELAY, R DELAY (L, C, R Delay Time) ..........................................
........................................................... [0000...1400ms, 1/64... 1/1]
These set the L, C, and R delay times.
The delay time is determined by these settings and the "TM RATIO" value.
p. 70 "L DELAY, R DELAY (L, R Delay Time)"
L LEVEL, C LEVEL, R LEVEL (L, C, R Delay Level)
These adjust the output level of the L, C, and R delays.
C FEEDBK (C Feedback) ..................................................... [000...127]
Sets the feedback amount of TapC.
TRIM................................................................................... [000...127]
Sets the input level.
SPREAD............................................................................... [000...127]
Sets the width of the stereo image of the effect sound.
The stereo image is widest with a value of 127, and the effect sound of both
channels is output from the center with a value of 0.
8. PAN.DELAY (Stereo Auto Panning Delay)
This is a stereo delay that uses an LFO to pan the delay sound between left
and right.
Effect guide
.................... [000...127]
71