Table of Contents
Advertisement
SYS EX (System Exclusive)............................................ [DISABLE, ENABLE]
Selects whether MIDI system exclusive messages will be transmitted and
received.
DISABLE: MIDI system exclusive messages will not be transmitted or
received.
ENABLE: MIDI system exclusive messages will be transmitted and
received.
MIDI.CTRL (MIDI Control)
In this page you can specify the function that is assigned for modulation
sources MIDI1, MIDI2, and MIDI3 used in a virtual patch.
If the selected function is assigned to a different parameter, an asterisk
NOTE
"*" is shown at the right of the value.
MIDI1.SRC
....[P.BEND...#119, #016+/–, #017+/–, #019+/–, #020+/–, #021+/–]
Selects the function that will be assigned to modulation source MIDI1 used
in a virtual patch. The factory-set default setting is CC#16.
MIDI2.SRC
....[P.BEND...#119, #016+/–, #017+/–, #019+/–, #020+/–, #021+/–]
Selects the function that will be assigned to modulation source MIDI2 used
in a virtual patch. The factory-set default setting is CC#02.
MIDI3.SRC
....[P.BEND...#119, #016+/–, #017+/–, #019+/–, #020+/–, #021+/–]
Selects the function that will be assigned to modulation source MIDI3 used
in a virtual patch. The factory-set default setting is A.TOUCH (aftertouch).
If you've selected #016+/– (CC#16+/–), #017+/–
(CC#17+/–), #019+/– (CC#19+/–), #020+/–
(CC#20+/–), or #021+/– (CC#0216+/–)
When a control change message is received from a
slider (value 0—127) on an external MIDI device, the
center position of the slider (control change value 64)
will produce a modulation effect of 0 on the
microKORG XL.
If you've selected #016, #017, #019, #020, or #021,
setting the slider etc. to a position of 0 (control
change value 0) will produce a modulation effect of 0
on the microKORG XL. Choose the type of setting that will produce the
desired result on the microKORG XL when you operate the sliders or other
controllers of your external MIDI device.
CC MAP (MIDI Control Change No. Map)
Here you can assign control change numbers to the most important param-
eters. When you use performance editing or program editing, using the
knob for these parameters will transmit the control change message that is
assigned here. When the assigned control change message is received,
the value of the corresponding parameter will change ( p. 83 "2.MIDI mes-
sages").
(Parameter) .....................................................[PORTMNTO...VC.EF.SENS]
Selects the knob parameter ( p. 34 "KNOB").
(Value) ................................................................. [NO.ASSIGN...CC#119]
Specifies a MIDI control change number (CC#) for the parameter selected
by "Parameter."
If another parameter is assigned to the number you select, an asterisk "*"
NOTE
will appear at the right of the number.
The MIDI channel for vocoder parameters will be the same MIDI channel
NOTE
as for timbre 1.
Parameter Guide
Select "#016±"
Select "#016"
0
0
61
Hide quick links:
Advertisement
Table of Contents
