Korg Microkorg XL User Manual page 67

KEY SYNC (LFO KeySync) ............................................................[OFF, ON]
Specifies how the LFO will be reset at note-on.
This parameter will be displayed and can be set if "MOD SRC" is LFO.
NOTE
Note on
With OFF, the LFO phase will not be reset when note-on occurs.
With ON, the first note-on from a condition of no keys being pressed will
reset the LFO to the phase specified by "INI.PHASE," and modulation will
be applied at that phase even if subsequent note-ons occur.
Note on
Note all off
This takes effect when a note-on occurs on the global MIDI channel.
INI.PHASE (LFO Init Phase) ...................................................[000...180°]
Specifies the starting position of the waveform.
With a setting of 0°, the waveform will start from its beginning at note-on.
With a setting of 180°, the waveform will start from the mid-point of its cycle
at note-on.
This parameter will be displayed and can be set if "KEY SYNC" is Tim-
NOTE
bre.
CTRL SRC (Control Source) ...................................[OFF, VELOCITY...MIDI3]
Selects the control source.
The filter will be controlled by the selected source.
This parameter will be displayed and can be set if "MOD SRC" is CTRL.
NOTE
Note on
Source Explanation
OFF Not used
VELOCITY Velocity
P.BEND Pitch bend
MOD.WHEEL Modulation wheel
MIDI1 Source specified by "MIDI1" in Global mode: MIDI
MIDI2 Source specified by "MIDI2" in Global mode: MIDI
MIDI3 Source specified by "MIDI3" in Global mode: MIDI
3. BAND EQ (4Band EQ)
This is a stereo EQ for which the type can be selected independently.
Stereo In - Stereo Out
Left
Band1 Band2 Band3 Band4
PEQ
Trim
LEQ
LEQ
Trim
PEQ
Right
DRY/WET...................................................... ["DRY", 99:1...1:99, "WET"]
Sets the balance between the effect and dry sounds.
TRIM................................................................................... [000...127]
Sets the input level of EQ.
Effect guide
Dry / Wet
PEQ PEQ PEQ
HEQ
HEQ
PEQ PEQ PEQ
Dry / Wet
67