Securam Basic User Instructions page 2

CHANGING YOUR COMBINATION
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
1. Enter "zero" six times.
2. Enter your existing six (6) digit combination one time.
3. Enter your NEW six (6) digit combination two times.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
5. Test lock operation several times before closing the door.
CAUTION: When selecting a combination do not use birthday or other predictable
data
that could give correlation between the user and combination.
• Valid Combination Entry - Double signal after valid six (6) digit combination is
entered.
• Invalid Combination Entry - Triple signal indicates the old combination is still
valid.
BATTERY LOW WARNING
• Repeated LED flashing and beeping during an opening indicates that the battery is
low and needs immediate replacement.
• Uses one (1) 9-Volt alkaline battery only. (Example: Duracell™ or Eveready™
alkaline batteries.) The replacement of batteries at least once annually is
recommended.
If battery is depleted and will not allow lock to open, follow instructions below.
Lock contains a non-volatile memory, even
with batteries removed the lock will retain all
programming.
CHANGING YOUR BATTERY
Note: Only use 9V Duracell Alkaline batteries.
Steps to change battery
1. Pull the TAB at the base of the keypad towards
you to release the battery.
2. Remove battery and replace with a new
9 volt Duracell Alkaline battery.
3. Reinsert the battery pod and ensure it is
firmly in place.
4. CAUTION: Fitting of an incorrect battery type
or battery with low life span (limited use by date)
may result in intermittent operational problems.