Completing The Main Memory Installation Procedure - HP Vectra XW User Manual

3 Slide each memory module into the slot at 90° to the system board
(hold the memory module with the cutouts closest to the processor).
Slide the memory module into
o
the slot at 90
4 Firmly press each memory module completely into the connector
until the retaining clips click into position.
5 Repeat this procedure for each pair of memory modules you are
installing.
6 Install any other accessories before replacing the cover (see page
38). Reconnect all cables and power cords.

Completing the Main Memory Installation Procedure:

1 Switch on the Personal Workstation. When
(indicating that the Power-On-Self-Test has detected a change in
your memory configuration) follow the displayed instructions to run
the Setup program.
2 Check that Setup has automatically detected and configured the
fields. Ensure the
Memory Size
incorrect, check that you have correctly installed the memory
modules.
3 Set the extended memory limit field to
for i286 processors (or earlier processors) that cannot work with
more than 16 MB total memory.
4 Press to save and exit the Setup program.
3 How to Install Accessories Inside Your Personal Workstation
Push the module until the retaining clips
click into position
memory is correct. If it is
TOTAL
if you use software designed
Y
Installing Main Memory
appears
Error 0250
English 45