Table of Contents
Advertisement
E1
2-2 97060A Environmental Installation,PM
Installation Procedure
1. Ensure that the HP 27II2A GPIO interface card has its switches set as shown:
W1, W2, W3
Jumper in 5V Position
+5
r:i:!le
+ 12
Jumper in 12V Position
+5 e£I:!J+12
W1
GPIO Interface Card Switch Settings
2. Install the HP 27II2A GPIO card in an interface card slot in the computer or HP 97098A I/O
Expander. and connect the GPIO interface cable to the card.
3. Connect the other end of the GPIO cable to the 97060A connector labeled "J9/GPIO
HOST".
4. Interconnect the 97060A and the monitor with the three 1.8-metre BNC cables. red to red.
green to green. and blue to blue.
5. Set the monitor so that the video signal is terminated with 75 ohms.
6.
If
you are installing the HP 911IA Data Tablet. connect an HP-IB cable from the 9I11A to
the 97060A input jack labeled "JI0'GPIB TABLET'. Ensure that the 9IIIA device address
is set to 6 and that no other interface cable is connected to the 9IIIA.
Advertisement
Table of Contents
