Takex PB-100AT-KH Instruction Manual

TAKEX
PB-100AT-KH : OUTDOOR 1OOm (330 ft.)
Thank for purchasing our "intelligent" quad photoelectric beam.
you
This unit will provide long term, dependable service when properly installed.
Please read this Instruction Manual carefully for correct and effective use.
This product is a photoelectric beam sensor designed
tower to be used
The beam
This sensor is designed to detect intrusion and to initiate an alarm
Please Note :
TAKEX is
surge by lightning), abuse, misuse, abnormal usage, faulty installation or improper maintenance.
[FEATURE]
The PB-100AT-KH beam is equipped with many features which provide a wide choice of field selectable options.
These options result in considerable flexibility for a variety of application requirements.
•
Anti-crawling
PB-100AT-KH is designed to prevent a crawling intrusion to
protection distance by means of OR-gated detection in addition
to
AND-gated detection.
•
Dual response time system
Two individual
response times
gates.
adjustment of AND/OR
This enables detection of intruders with minimum false alarms.
/AND-gated : Set at faster
at
OR-gated : Set slower response time
'
•
High power infrared
The active infrared transmission is exceptionally strong with a
maximum arrival distance
protection distance.
•
Four channel frequency selection
separate choices of frequency avoids cross-talk.
4
•
Beam transmission strength selection
2 levels of beam transmission strength which can be set to suit
the protection distance.
[BASIC OPERATION DESCRIPTION]
This anti-crawl sensor was developed for high security applications
PB-IN-HFA series quad photoelectric beam sensors.
(Basic system)
Transmitters project separate double pulse modulated beams of
different pulse pattern.
Receivers only respond to the individual transmitted beam.
(Transmitter)
PHOTOELECTRIC BEAM SENSOR
Instruction Manual
to
is recommended to
be rated
not
responsible for damage, injury
are provided for separate
response time
\
/
ten times greater than the specified
(Receiver)
a beam tower
be installed in (sold
IP 55 or more.
; it is
or losses caused
by accident, theft,
•
Auto-gain lock
Optimal sensitivity gain is automatically set at any protection
distance up to the maximum protection distance.
indicates setting is completed.)
•
Environmental module
Environmental trouble signal is
is reduced below an acceptable level.
•
Programmed AGC function
Sensitivity is automatically increased in bad weather
with fog, rain, or frost.
•
Audible signal for aligment
An alignment tone aids in quick set-up of beams for electrical
measurement of alignment.
•
Other features
Monitor output, Beam selector
to detect a crawling intrusion and are based on our
(Basic operation)
The following basic
intrusion and minimize false alarms.
Individual beam detection : An alarm is not initiated by instantaneous
All beam detection
Response time
1)
OR-gated on receiver unit.
4 channel frequency selection is available. : See 6.1 Four channel
2)
frequency selection.
[ANTI-CRAWL]
separately).
not
a burglary or a crime preventing device.
Acts of God
(including inductive
sent
when beam
to detect
operation is required
beam interruption, but an alarm is
initiated when the interruption continues
response time. (OR
set
during a
The response time should be
which will detect crawling intrusion and
minimize false alarm risk due
animals.
An alarm is initiated when both sets of
:
beams are interrupted during a
response time. (AND gated)
Separately adjustable for AND-gated or
(Audible tone
reception level
to
contend
a crawling
gated)
set at a time
to
small
set