Takex PB-100AT-KH Instruction Manual

Photoelectric beam sensor (anti-crawl)

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Takex PB-100AT-KH

  • Page 2: Parts Description

    PARTS DESCRIPTION Functions / Indcations View finder Mirror [Transmitter] Horizontal angle Operation LED adjuster Beam power Vertical angle (H set at factory) adjuster Terminals Beam channel frequency selectable switch (frequency 1-4) (1CH. set at factory) Gain lock switch (Receiver only) [Receiver] Beam channel TR : Shading plate Sensitivity attenuation...
  • Page 3 4) 2-stacked standard connection. 5) When environmental module is used. Power } (12VDC) } Power (12VDC) } Alarm } Alarm } Tamper (1b) Control panel 2 3 4 2 3 4 8 9 10 } (CH.1) Environmental signal (1C) 2 3 4 Contorol panel [Cautions on wiring] (CH.3)
  • Page 5: Functions Description

    [Note] The use of a voltmeter for alignment is advised to ensure highest level of stability. Consult with TAKEX distributor or TAKEX regional office about the frequency selection for installations not mentioned in this instruction manual. Inappro- preate choice of frequency may cause malfunction.
  • Page 6 2) A "beep" tone is issued from the receiver approximately 5 seconds after the lock spacer is inserted into position. This tone indicates the Auto-gain has been set. Refer to the chart below. Tone Indicates Result Cause Remedy One pulse Optimal sensitivity has (Beep) been set.
  • Page 7: Troubleshooting

    (Units should be tested on a regular weekly basis) SPECIFICATIONS Model PB-100AT-KH Near infrared beam interruption system (TR,-RE 4 beams simultaneous interruption or upper 2 beams interruption or Detection system lower 2 beams interruption)
  • Page 8: External Dimensions

    Limited Warranty : TAKEX products are warranted to be free from defects in material and workmanship for 12 months from original date of shipment. Our warranty does not cover damage or failure caused by Acts of God (including inductive surge by lightning), abuse, misuse, abnormal usage, faulty installation, improper maintenance or any repairs other than those provided by TAKEX.

Table of Contents