Fujitsu FI-5650C Operator's Manual page 144

CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
8.1 Document size
8.2 Document quality
8.3 Maximum ADF capacity
8.4 Area not to be perforated
8.5 Double feed detection conditions
8.6 Background Color Areas
8.7 Job Separation Sheet
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
8.2 Document quality (Continued)
Do not use the following documents:
Paper-clipped or stapled documents
Documents on which the ink is still wet
Documents smaller than A8 (Portrait) in size
Documents wider than A3 or 11 in. x 17 in. size
Documents other than paper such as fabric, metal foil, or transparencies
ATTENTION
When scanning semi-transparent documents, set the density to light to avoid bleed through.
To prevent the rollers from becoming dirty, avoid scanning documents containing large areas written or filled in pencil. If scanning of
such documents is inevitable, clean the rollers more frequently.
Carbonless paper contains chemical substances that may harm the Pad ASSY or rollers (e.g. Pick roller) when documents are fed.
Pay attention to the following:
Cleaning :
If pick errors occur frequently, clean the Pad ASSY and the Pick roller. For details on clean the Brake roller and the Pick roller set. For
details on cleaning the Brake roller and the Pick roller set, refer to
Replacing parts :
The service life of the Pad ASSY and the Pick roller may be shortened compared to the case of scanning wood containing paper
documents.
When scanning wood containing paper, the life of the Pad ASSY and the Pick roller may be shortened compared to the case of
scanning wood free paper.
When using the ADF, the leading edge of all document sheets must be evenly aligned. Make sure that curling at the leading edge is
within the following tolerances:
All Rights Reserved, Copyright (C) PFU LIMITED 2004
"4.2 Cleaning the ADF".
1 | 2