Platform_Span Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

PLATFORM_SPAN Messages

Error Message PLATFORM_PM-3-INTVLANINUSE: internal vlan-id [dec] allocated for
interface [chars] is still in use.
Error Message PLATFORM_PM-3-NOINTVLAN: internal vlan of interface [chars] is not
active for vlan-id [dec].
PLATFORM_SPAN Messages
This section contains the Switched Port Analyzer (SPAN) messages.
Error Message PLATFORM_SPAN-3-PACKET_DROP: Decreases egress SPAN rate.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-44
Explanation This message means that an internal VLAN ID allocated for an interface is still in use.
[dec] is the VLAN ID, and [chars] is the interface.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
This message means that internal vlan_data is not active for the given VLAN ID. [chars]
Explanation
is the interface, and [dec] is the VLAN ID.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
This message means that egress SPAN rates are falling because SPAN is enabled with
Explanation
multicast routing or fallback bridging.
Find out more about the error by using the show tech-support privileged EXEC
Recommended Action
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting Cisco, see the
Traceback Reports" section on page
Chapter 2
1-3.
1-3.
1-3.
Messages and Recovery Procedures
"Error
"Error
"Error Message
OL-9641-04