Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message EC-5-NOLACP: Invalid EC mode, LACP not enabled.
Explanation
included in the software image.
Recommended Action
Error Message EC-5-NOPAGP: Invalid EC mode, PAgP not enabled.
Explanation
EtherChannel mode cannot be set to desirable or auto.
Recommended Action
channel-group channel-group-number mode on interface configuration command.
Error Message EC-5-PORTDOWN: Shutting down [chars] as its port-channel is
admin-down.
Explanation
administrative state of its aggregate port. If the administrative state of the aggregate port is down,
the administrative state of the port is also forced to be down. [chars] is the physical interface.
Recommended Action
to activate the aggregation port.
Error Message EC-5-STAYDOWN: [chars] will remain down as its port-channel [chars] is
admin-down.
Explanation
of the affected port. If the aggregation port is administratively down, all ports in the aggregation port
are forced to be administratively down. The first [chars] is the physical interface, and the second
[chars] is the EtherChannel.
Recommended Action
port to activate (unshut) the aggregation port.
Error Message EC-5-STAYDOWN: no-shut not allowed on [chars]. Module [dec] not online.
Explanation
enabled by using the no shutdown interface configuration command because it is a member of an
EtherChannel group and that EtherChannel group has been administratively shut down. The
interface has an EtherChannel configuration, but no information is available yet about its port
channel. [chars] is the interface, and [dec] is the module.
Recommended Action
port-channel setting of the EtherChannel.
OL-9641-04
This message means that the EtherChannel mode cannot be set because LACP is not
Install a software image that includes LACP, and set the EC mode to on.
This message means that PAgP is not included in the Cisco IOS image and that the
Obtain an image with PAgP included, or set the mode to on by using the
This message means that the administrative state of the port is controlled by the
Enter the no shutdown interface configuration command on the aggregate port
This message means that the administrative state of the aggregation port overrides that
Enter the no shutdown interface configuration command on the aggregation
This message means that an interface with an EtherChannel configuration cannot be
No action is required. Wait until the module is online to find out the
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
EC Messages
2-23
Advertisement
Table of Contents
