Table of Contents
Advertisement
MAC_MOVE Messages
Error Message MAC_LIMIT-4-EXCEED: Vlan [dec] with Configured limit = [dec] has
currently [dec] Entries.
MAC_MOVE Messages
This section contains the MAC_MOVE messages.
Error Message MAC_MOVE-4-NOTIF: Host [enet] in vlan [dec] is flapping between port
[chars] and port [chars].
PAGP_DUAL_ACTIVE Messages
This section contains Port Aggregation Protocol (PAgP) dual-active detection messages.
Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]
informing virtual switches of dual-active: new active id [enet], old id [enet]
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-36
Explanation
This message means that the number of MAC address entries for a VLAN exceeds the
maximum number allowed. The first [dec] is the VLAN ID, the second [dec] is the maximum
number of MAC address entries, and the third [dec] is the number of entries in the MAC address
table.
Your system administrator configures an action.
Recommended Action
Explanation
This message means that the host is moving between the specified ports. [enet] is the
Ethernet address of the host, [dec] is the VLAN ID, the first [chars] is the first port, and the second
[chars] is the second port.
Recommended Action
Check your network for loops.
Explanation
The switch cannot create the specified managed object. [chars] is the object name.
No action is required.
Recommended Action
PAgP received a new active ID on the specified interface, which means that all virtual
Explanation
switches are in a dual-active scenario. The interface is informing virtual switches of this, which
causes one switch to go into recovery mode. [chars] is the interface. The first [enet] is the new
active ID. The second [enet] is the ID that it replaces.
No action is required.
Recommended Action
Chapter 2
Messages and Recovery Procedures
OL-9641-04
Advertisement
Table of Contents
