Finding A Dante Device Ip Address - Extron electronics AXI 22 AT D Plus Setup Manual

Device View
The dialog populates with the selected AXI 22 AT D Plus information. Identify the current device by causing its LEDs to
flash, using the Identify
Figure 7. Device View Dialog Box
5.
Click the Device Config
Figure 8. Device Configuration Tab
6.
In the Rename Device
(DNS) hostname rules (refer to the Dante Controller section of the AXI 22 AT D Plus User Guide for a full list of device name rules).
7.
Click ( ). A confirmation prompt opens. Read the prompt carefully.
Apply
3
8.
Click Yes to enter the new name, then close the
The new name is written to the AXI 22 AT D Plus. Repeat as necessary for all devices.
NOTE:
After the AXI 22 AT D Plus is renamed, it can remain connected to the network. However, subsequent devices should be
connected one at a time and must be renamed before the next device is connected.

Finding a Dante Device IP Address

To find the IP address of a Dante device, the name of the device is needed
NOTE: If the AXI 22 AT D Plus has not been renamed, its default name consists of the product name followed by a hyphen (
plus the last 6 digits of the unit MAC address (for example,
1.
Open Dante Controller.
2. Dante Controller Network - View
On the
3.
Device Info
On the
In figure 9, the IP address is
Figure 9. Dante Controller Network - View
( eye ) button (see figure 7,
tab (see figure 8, ) to open the device configuration page.
1
panel, enter the new name of the device in the text field (
Device Configuration
screen, click the
page, locate the name of your AXI (
192.168.254.254 .
).
1
2
dialog box.
Renaming a Dante Device
AXI22DP-0744b2
).
Device Info tab (see figure 9,
). The IP address is in the
2
). Device names follow Domain Name System
on page 4.
).
1
Primary Address
column (
AXI22DP- )
).
3
5