Table of Contents
Advertisement
●
To set HDMI CEC [HDMI CEC Setting]
(1) Confirm that the HDMI CEC setting of the external device is enabled.
For details on the setting, refer to the manual of the external device.
( 2 ) Choose [Monitor Settings] in the Setting menu and press
(3) Choose [HDMI CEC Setting] in the [Monitor Settings] menu and press
.
The [HDMI CEC Setting] menu appears.
(4) Set each item.
1. Choose the setting item with p or q and press
The setting menu of the selected item appears.
2. Select the setting with t or u , and then press
The setting is completed.
●
To perform play operation and menu operation
Operate the Link Menu.
(1) Press
on the remote control.
The Link Menu appears.
The input signal and the
name of currently
controllable device is
displayed.
(When changing the
controlled device, see
below.)
■
When switching controlled device
(1) Press
.
The list of controllable devices appears.
"√" mark is displayed next to the currently selected device.
Device List
Return
Search Devices
✓
HDMI1 Recorder
HDMI2 Player
: Select [ENTER] : Enter
(2) Select the device to be controlled with p or q , and then press
The setting is completed.
■
How to use
The mode of the Link Menu can be changed by pressing [Change Mode]. The
available operation differ according to modes.
- Controlling the play of external devices (Play and stop, forward and reverse)
- Controlling the menu of external devices (control menu, power on/off)
Press
to switch the mode, and then press the appropriate buttons to the
operation of each mode on the remote control. (See
Appears when the external device does not
correspond to the control from the monitor.
Indicates the power status
HDMI1 Recorder
of the connected external
Play
device.
Change Mode
Green : Power on
Search
Search
Gray
Orange: is powering up /
Stop
MENU
Device List
EXIT
Close Link Menu
Link Menu
page
.
.
.
: Power off
is powering off
.
18)
NOTE
NOTE
• When not using the HDMI CEC
• When not using the HDMI CEC
function, Power On Link, or Power
function, Power On Link, or Power
Off Link, set "Disable" to each of
Off Link, set "Disable" to each of
them.
them.
• While [HDMI CEC] is at "Disable",
• While [HDMI CEC] is at "Disable",
[Power On Link] and [Power Off
[Power On Link] and [Power Off
Link] cannot be selected.
Link] cannot be selected.
Attention
Attention
• If the device list is displayed with
• If the device list is displayed with
the message "There are no operable
the message "There are no operable
devices." when pressing
devices." when pressing
that the device is connected correctly
that the device is connected correctly
and the power is turned on, and then
and the power is turned on, and then
select [Search Devices] and press
select [Search Devices] and press
.
.
• Press
• Press
to close the Link Menu.
to close the Link Menu.
NOTE
NOTE
• If the target device is not displayed in
• If the target device is not displayed in
the device list, confirm that the device
the device list, confirm that the device
is connected correctly and the power
is connected correctly and the power
is turned on, and then select [Search
is turned on, and then select [Search
Devices] and press
Devices] and press
.
.
• The controlled device can also be
• The controlled device can also be
changed by switching the input signal.
changed by switching the input signal.
Chapter 2 Operation
, confirm
, confirm
17
Advertisement
Table of Contents
