Canon Laser Shot LBP5000 User Manual page 385

Cause 6
Remedy
The ERR indicator on the network board is on.
Cause
Remedy 1 Make sure the network cable is connected properly.
Remedy 2 Replace the network cable with a proper one and check if there is no
Remedy 3 If the ERR indicator still comes on even after applying the Remedy 1 and 2,
The ERR indicator on the network board blinks at an interval of four times.
Cause
Remedy
The ERR indicator on the network board keeps blinking.
7
Cause
Remedy
7-38 Problems on Installing the Network Board
The hardware of the network board is in an abnormal condition.
Report the problems to your local authorized Canon dealer.
The network cable is disconnected or broken, or the network board is not
installed properly.
disconnection or damage.
contact your local authorized Canon dealer for servicing.
The DIP switch 1 on the network board is ON.
Set the DIP switch 1 to OFF once.
The hardware of the network board is in an abnormal condition.
Contact your local authorized Canon dealer for servicing.