Canon Laser Shot LBP5000 User Manual page 341

1
2
3
4
6
5
6
6-28 Network Board
Turn the printer and computer OFF, remove the USB cable,
and then disconnect the power plug from the AC power outlet.
Remove all the interface cables and the power cord from the
printer.
Remove the two screws and remove the network board.
IMPORTANT
Do not touch the network board parts, printed wire, or connectors with your hands.
Set the DIP switches.
Set the DIP switches with the tip of a ball-point pen etc. For details on methods
for setting the DIP switches, see the table of p. 6-27.
E R R
C 1
N B -
Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board while
aligning it with the guide rails inside the expansion slot.
IMPORTANT
• Do not touch the network board parts, printed wire, or connectors with your hands.
• Insert the printer connector of the network board securely into the connector inside
the expansion slot.
Secure the top and bottom portions of the network board with
the two screws supplied with the network board.
DIP switches
1 2
OFF
1 0 0
L N K
ON
3 4
OFF