Canon Laser Shot LBP5000 User Manual page 345

5
6
7
6
8
9
10
11
6-32 Network Board
IMPORTANT
When setting the DIP switches, be careful not to damage the main board with the
tip of a ball-point pen etc. Do not use a sharp object such as a mechanical pencil.
Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board while
aligning it with the guide rails inside the expansion slot.
IMPORTANT
• Do not touch the network board parts, printed wire, or connectors with your hands.
• Insert the printer connector of the network board securely into the connector inside
the expansion slot.
Secure the top and bottom portions of the network board with
the two screws supplied with the network board.
Connect the power cord.
Plug the power plug into the AC power outlet.
Press " " of the power switch to turn the printer ON, wait until
the (Ready) indicator comes on, and then press "
power switch to turn the printer OFF.
Disconnect the power plug from the AC power outlet.
Remove the power cord.
" of the