Canon Laser Shot LBP5000 User Manual page 368

Outlines in the areas dense in color are emphasized.
Cause Depending on the print data, outlines in the areas dense in color are sometimes
emphasized.
Remedy Set [Special Print Mode] to [Special Settings 10] in the printer driver. If this
solves the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
A portion of a page is not printed.
Cause 1 The scale factor is incorrect.
Remedy 1 Clear the [Manual Scaling] check box in the printer driver. If the check box is
cleared, the scale factor will be set according to [Page Size] and [Output Size]
automatically.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.
Remedy 2 Select the [Manual Scaling] check box in the printer driver, then specify an
appropriate scale factor according to the paper size to be used.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.
Cause 2 The position of the paper is incorrect.
Remedy Load the paper properly. (See "Loading Plain Paper, Heavy Paper,
Transparencies, or Labels in the Paper Source," on p. 2-14, "Loading Index
Card Size Media in the Paper Source," on p. 2-26, "Loading Envelopes in the
Paper Source," on p. 2-37, "Loading Custom Size Paper (Non-Standard Paper)
in the Paper Source," on p. 2-47)
Cause 3 A document with no margins was printed.
Remedy Data cannot be printed within a 5 mm margin (10 mm for envelopes) on all sides
of the paper. Secure a margin of 5 mm or more (10 mm or more for envelopes)
around the data.
The printing position is skewed.
Cause 1 [Gutter] is specified.
Remedy Specify [Gutter] in the printer driver to [0].
In order to specify the setting for [Gutter], display the [Gutter Settings] dialog
box by clicking [Gutter] in the [Finishing] sheet.
Print Quality Problems
7
7-21