Resetting The Network Board - Canon Laser Shot LBP5000 User Manual

Resetting the Network Board

If you want to reset the network board to the default values, use the Remote UI or
FTP Client. For details on the Remote UI, see "Chapter 3 Various Functions of
Remote UI" in Remote UI Guide, and on FTP Client, see "Chapter 5 Appendix" in
Network Guide.
Even if none of the above procedures work, you can reset the settings for the
network board by manipulating the DIP switches using the following procedure. A
Phillips screwdriver is required to reset the settings for the network board. Have a
screwdriver ready in advance that matches the size of the screws.
1
Turn the printer and computer OFF, remove the USB cable,
and then disconnect the power plug from the AC power outlet.
2
Remove all the interface cables and the power cord from the
printer.
3
Remove the two screws and remove the network board.
IMPORTANT
Do not touch the network board parts, printed wire, or connectors with your hands.
4
Switch the DIP switch 1 to ON.
Set the DIP switches with the tip of a ball-point pen etc.
ON
1 0 0
L N K
E R R
C 1
N B -
DIP switch 1
1
2 3 4
OFF
Network Board
6
6-31