Canon Laser Shot LBP5000 User Manual page 365

Cause 2
Remedy
Cause 3
Remedy
Residual images appear on non-printed areas.
Cause 1
Remedy
Cause 2
Remedy 1 To lower the temperature of the fixing unit, wait for a while before printing again.
Remedy 2 In the Printer Status Window, select [Device Settings] from the [Options] menu,
7
Cause 3
Remedy
The overall print result is faint.
Cause 1
Remedy
Cause 2
Remedy
7-18 Print Quality Problems
Paper is damp since the paper has been stored in unsuitable condition.
Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 2-2)
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 5-2)
Printing paper is inappropriate.
Change the paper and print again. (See "Paper Requirements," on p. 2-2)
Paper of a wider width was printed just after paper with a narrower width (A5
size etc.) was printed continuously.
point to [Small-size Paper Special Setting], and then set [Small-size Paper
Special Process] to [Image Quality Priority] (However, this may lengthen the
waiting time before the operation begins).
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 5-2)
The setting for [Toner Density] is not appropriate.
Drag the [Toner Density] slider in the printer driver toward [Dark].
In order to specify the setting for [Toner Density], display the [Custom Settings]
dialog box by clicking [Settings] in the [Quality] sheet.
[Use Draft Mode] is enabled.
Clear the [Use Draft Mode] check box in the printer driver.
In order to specify the setting for [Use Draft Mode], display the [Custom
Settings] dialog box by clicking [Settings] in the [Quality] sheet.