Operation - Tru-Test speedrite Delta 1B Instruction Manual

Mounting the energizer
For exterior installations, ensure that the energizer is
protected from animals and the environment. If
necessary, house the energizer in a protective box.
Consider site access, proximity to a suitable area for
earthing and whether the energizer is safe from
human interference. Try to position the energizer as
near as possible to the centre of the electric fence.
For interior installations, make sure the energizer and
battery are level. Mount them above floor level and
out of reach of children.
Warning!
- Do not connect to mains-operated or line-
operated equipment.
- Disconnect the battery from the energizer before
charging.
- When charging, ensure that there is adequate
ventilation to allow gases to disperse.
2
Solar installation
Solar panel selection, assembly and positioning
Refer to the "Speedrite Solar Selection Guide" for
information about selecting components, assembling
and positioning a solar energizer system.

Operation

- Keep this manual in a handy location.
- Carefully read all the safety information in this
manual. See Safety Considerations on page 9.
- Carefully check your installation to ensure that it
complies with all local safety regulations.
Select the output setting using the Power Output
•
switch (see Power Output switch on page 3). One
of the three output performance indicator lights
will flash with each pulse. The lights indicate the
approximate voltage at the Fence output
terminals, except when the Power Output switch
is set to Full Power with Battery Test.
Recommended.
Indicates a load on the
energizer. Attention required
to ensure reliable animal
control.
Fence is heavily loaded and
needs urgent attention.
If at any time all the indicator lights flash for
•
more than 10 seconds, turn off the energizer for
approximately 10 seconds, then turn it on again.
If the indicator lights continue to flash, return the
•
energizer to the nearest authorised service agent.