Page 1
Control Box CB4M 2024.08_V2.0 Revision Technical changes may be made to improve the product without notice!...
Page 2
1. I/O Introduction 1.1 CB4M AC power cord Hand control #1 Actuator #4 Hand control #2 Actuator #3 Actuator #2 Actuator #1 1.2 CB4M-B / CB4M-S AC power cord Hand control #1 Actuator #4 Actuator #3 Actuator #2 Actuator #1...
Page 3
⑧ Actuator #4 retracts ⑧ HD hand control 3. Installation & Operation for CB4M-B & CB4M-S 3.1 Precautions Before Installation For safety reasons during initial installation, the entire set of products, including the actuator, must complete the electrical connection and perform the "stroke learning"...
Page 4
3.2.2 For CB4M-S (Take DKP3 hand control as an example) (1) When CB4M-S and DKP3 are connected and power on at the first time, the display of DKP3 flashes “SEt”. Only learing procedure can be excuted now. All four actuators must be connected to the CB4M-S control box.
Page 5
Terms of Use The user is responsible for the suitability of MOTECK products, and the products listed on the MOTECK website are subject to change without notice. MOTECK reserves the right to terminate sales or delete any products displayed on the website or listed in its catalog.
Need help?
Do you have a question about the CB4M and is the answer not in the manual?
Questions and answers