Fixture Menu; Configuration - Robe Anolis ArcPower Unit Pixel Rack Mount Manual

Table of Contents

7. Fixture menu

The ArcPower Unit Pixel menu allows to set the fixture according to your needs, obtain information on its op-

eration and program it, if it has to be used in a Stand-alone mode.

The fixture´s menu can is controlled directly by touching desired icon.

After switching the fixture on, the display shows the initial screen for a few seconds

and after that the main menu screen will appear.

Icons used in the touch screen menu.

- [back arrow] used to move to the previous screen

- [forward arrow] used to move to the next screen.

- [up arrow] used to scroll menu up.

- [down arrow] used to scroll menu up.

- [confirm] used to save adjusted values, to leave menu or to perform desired action.

- [cancel] used to leave menu item without saving changes.

- [back arrow] used to move to the main screen

DMX Address ---Use the menu item to set DMX address of the ArcPower Unit Pixel, which is defined as the

first channel from which the ArcPower Unit Pixel will respond to the DMX controller.

DMX mode --- The menu item allows to select desired DMX mode (Mode 1-fixed, Mode 2-8 bit, Mode 3 -full

16 bit, Mode 4-fixed order, Mode 5- without global effects). This menu item serves for LED zones only (not for

pixel zones).

DMX In --- The menu item allows to choose type of fixture control:

Wired - DMX signal is received by means of the standard DMX cable.

Ethernet- The signal is received by means of the Ethernet cable, supported protocols

are ArtNet, MANet, MANet2, sACN.

Table of Contents

Do you have a question about the Anolis ArcPower Unit Pixel Rack Mount and is the answer not in the manual?

Anolis arcpower unit pixel rack mount us Anolis arcpower unit pixel rack mount us lvAnolis arcpower unit pixel wall mountAnolis arcpower unit pixel wall mount usAnolis arcpower unit pixel wall mount us lv