Dmx 512 Operation - Robe Anolis ArcPower Unit Pixel Rack Mount Manual

Table of Contents

Incorrect mounting:

5.3. DMX 512 operation

The ArcPower Unit Pixel is equipped with 5-pin XLR sockets for DMX input and output. Only use a shielded

twisted-pair cable designed for RS-485 and 5-pin XLR connectors in order to connect the fixture with the DMX

controller or one fixture with another.

To build a DMX chain.

1. Unplug ArcPower Unit Pixels from the mains before installation.

2. Connect the LED modules to the ArcPower Unit Pixels.

3. Connect ArcPower Unit Pixel s each other. Max. 32 fixtures may be connected on a DMX link.

Terminate the DMX link by installing a termination plug in the output of the last fixture.

The termination plug is a male 5-pin XLR plug with a 120 Ohm resistor soldered between Signal (–)

and Signal (+).

4. Connect ArcPower Unit Pixels to mains.

5. Set each ArcPower Unit Pixel.

6. Connect the DMX controller to the first fixture.

Table of Contents

Do you have a question about the Anolis ArcPower Unit Pixel Rack Mount and is the answer not in the manual?

Anolis arcpower unit pixel rack mount us Anolis arcpower unit pixel rack mount us lvAnolis arcpower unit pixel wall mountAnolis arcpower unit pixel wall mount usAnolis arcpower unit pixel wall mount us lv