Configuration Of Terminals; Installation; Connection To Mains - Robe Anolis ArcPower Unit Pixel Rack Mount Manual

4. Configuration of terminals

DMX In/Out
(XLR mounting sockets)
Pin 1: Shield
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: Not connected
Pin 5: Not connected
LED pixel zone output

5. Installation

5.1 Connection to mains

The ArcPower Unit Pixel must be installed by a qualified electrician in
accordance with all national and local electrical and construction codes and
These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.
This device falls under protection class I. Therefore the ArcPower Unit Pixel has to
be connected to a mains socket outlet with a protective earthing connection.
The ArcPower Unit Pixel Rack Mount (ArcPower Unit Pixel Wall Mount) is equipped with auto-switching power
supply that automatically adjusts to any 50-60Hz AC power source from 100-240 Volts. Connect the fixture to
the mains by means of inbuilt power cord.
The ArcPower Unit Pixel Rack Mount US (ArcPower Unit Pixel Rack Mount US) and the ArcPower Unit Pixel
Rack Mount US LV (ArcPower Unit Pixel Rack Mount US LV) and are equipped with auto-switching power
supply that automatically adjusts to any 50-60Hz AC power source from 100-277 Volts. Connect the fixture to
Pin 1: TX+
Pin 2: TX-
Pin 3: RX+
Pin 4: Not connected
CAUTION!
regulations.
6
Ethernet
(RJ 45 female)
Pin 5: Not connected
Pin 6: RX-
Pin 7: Not connected
Pin 8: Not connected
Trigger input and 12V output