Acer Altos G320 Series User Manual page 91

Network activity indicator does not light.
Do the following:
• Make sure the correct network drivers are loaded on the system.
• Network might be idle. Try accessing the server.
Server hangs when the drivers are loaded.
Change the PCI interrrupt settings.
System boots when installing a PCI card.
System Server Management feature require full-time standby power.
This means some parts of the system have power going to them
whenever the power cord is plugged in, even if you have turned the
system power off with the power button on the front panel. If you
install a PCI card with the AC power cord plugged in, a signal may be
sent to command the system to boot. Before installing a PCI card, you
should always:
• Power off the server.
• Unplug the AC power cord(s) from the server.
There is problem with the application software.
Do the following:
• Verify that the software is properly configured for the system.
Refer to the software installation and operation documentation
for instructions on setting up and using the software.
• Try a different version of the software to see if the problem is with
the copy you are using.
• Make sure all cables are properly connected.
• If other software runs correctly on the system, contact your vendor
about the defective software.
81