Table of Contents
Advertisement
108
The indicator for the selected drive changes from READY to ONLIN
A[array number]-[drive number]. For example, ONLIN A1-
3 means disk drive 3 in array 1.
3
Press Enter after you finish creating the current array.
4
Press F10 to configure logical drives.
5
Set the RAID level for the logical drive by highlighting RAID, then
press Enter.
A list of the available RAID levels for the current logical drive
appears.
6
Select a RAID level, then press Enter.
7
Set the logical drive size by selecting Size, then press Enter.
By default, the logical drive size associates the available space in
the array(s) with the current logical drive.
8
Set the stripe size.
9
After defining the current logical drive, select Accept, then press
Enter.
10 Save the configuration when the CU prompts you to do so.
11 Initialize the logical drives. Refer to "Initializing logical drives" on
page 109 for detailed instructions.
Appendix B: SATA RAID configuration
Advertisement
Table of Contents
Troubleshooting
