Acer Altos G320 Series User Manual page 87

• If you are using the onboard diskette controller, use BIOS setup on
page 45 to make sure that onboard "Floppy A" is set to 1.44 MB,
3.5-inch.
HDD activity indicator does not light.
Do the following:
• Make sure the drive is not disabled in the BIOS setup utility.
• Make sure the drive's power and data cables are connected
correctly.
• Make sure the drive is compatible.
• Make sure you have not exceeded the power budget for the
server.
• If using SATA drives, make sure that the master or slave settings
are set correctly. See your drive documentation for details on
setting the master or slave settings.
• If using SCSI drives, make sure that each SCSI ID number is unique
on the SCSI bus. See your drive documentation for details on
setting the SCSI ID for your drives.
• If using a RAID configuration with SATA or SCSI drives, make sure
the RAID card is installed correctly.
HDD activity indicator does not light.
If you have installed one or more hard drives in the system, do the
following:
• Make sure the power and signal cables are connected correctly.
• If using SATA or SCSI drives, check that relevant switches and
jumpers on the hard drive and backplane board are set correctly.
DVD/CD drive activity indicator does not light.
Do the following:
• Make sure the power and signal cables are properly installed.
• Check that relevant switches and jumpers on the drive are set
correctly.
77