Resetting The Hub - D-Link DFE-2600 User Manual

Dual-Speed Stackable Hubs User's Guide
DFE-2600 Stackable Hub - Network Monitoring : Bridge Information
Hub ID
1
2
3
5

Resetting the Hub

You can use the console program to reset the hub stack, either doing a system
reset (which restarts the hubs and is identical to powering them off and back
on again) or a factory reset (which resets the master hub, reverts all of its
parameters back to their factory default values, and restarts the entire hub
stack).
Important Note:
68
Bridge Present Bridge Status
Bridge Enable
N/A Disable
N/A Disable
N/A Disable
If it is necessary for you to power-off
the hub (or hub stack) and then re-
start it instead of using the reset
functions, the
POWERED-OFF for a MINIMUM of
TEN SECONDS.
Master Hub Setup and Management
EXIT
hub MUST BE