D-Link DFE-2600 User Manual page 20

Dual-Speed Stackable Hubs User's Guide
LED Indicator Panel
Refer to the next chapter, Understanding Indicators, for detailed infor-
mation about each of the hub
Twisted-Pair Ports
Use any of these ports to connect stations to the hub. The ports are MDI-
X Nway ports, which means you can use ordinary straight-through
twisted-pair cable to connect the hub to PCs, workstations, or servers
through these ports, and the speed of the connection will be detected
automatically. If you need to connect to another device with MDI-X
ports such as another hub or an Ethernet switch, you should use a cross-
over cable, or connect using the Uplink port (described below). For more
information about crossover connection, see the Crossover Cables section
on page 112.
Uplink Port
The Uplink port is an MDI port, which means you can connect the hub (or
hub stack) to another device with MDI-X ports using an ordinary straight-
through cable, making a crossover cable unnecessary.
Port 1 and the Uplink port are the same logical port, except their pinouts
are different. Do not use both Port 1 and the Uplink port at the same
time.
8
LED indicators.
Unpacking and Setup