D-Link DFE-2600 User Manual page 15

Full hub stack and network management provided via an SNMP man-
agement agent (DFE-2616i, DFE-2616ix, DFE-2624i, DFE-2624ix).
An optional slide-in switch module allows bridging between 10Mbps
and 100Mbps segments. Only one switch module is needed per stack,
but managed hub stacks can make use of additional switch modules
for redundancy.
LED indicators for power, collisions, link, network activity, parti-
tioning status, disable, operating speed (10 or 100Mbps) and network
utilization.
Digital hub ID number front panel display.
Auto-partition protection.
Data collision detection and handling.
Preamble regeneration, signal retiming.
Two proprietary daisy-chain ports for cascading up to five hubs to
form one logical hub; management provided via a master hub.
Standby backup master capability when two master model hubs are
present within a single stack.
Uplink port allows easy linking of two Fast Ethernet or four Ethernet
hub stacks to further expand your network.
Standard-size (19", 1.25U height), rack mountable
Built-in, removable power supply, replaceable without opening the
hub. Power supply is easily removed and replaced. Automatic volt-
age selection (100V to 240V, 50 or 60Hz) without fuses to change or
a voltage switch to set.
Optional slide-in modules: Switch, 100BASE-TX, and 100BASE-FX
(see Chapter 4 : Making Connections).
Introduction 3