D-Link DFE-2600 User Manual page 119

same as an Event index number identified in the Event group. If there is
no corresponding entry in the Event Table, then no association exists and
no event will be generated. In particular, if this value is zero, no associ-
ated event will be generated, as zero is not a valid event index number.
Event
The Event Group controls the generation and notification of events. Each
entry in the Event Table describes the parameters of the event that can be
triggered. Each event entry is fired by an associated condition located else-
where in the MIB – in the case of this software utility, the Alarm Group.
To define a set of parameters that describe an event to be generated when
certain conditions are met, enter the appropriate information in the fields to-
wards the bottom of the Event window and click on the Add button -or- use
Add under the Alarm Table which will automatically create the event entry.
Event Table
The Event Table consists of a list of events to be generated when an event is
fired and is shown below. To Add a new event to the Event Table, simply fill
in the appropriate information in the boxes towards the bottom of the screen
and click on the Add button.
Web-Based Network Management 107