Monitoring The Hub Stack; Port State - D-Link DFE-2600 User Manual

Dual-Speed Stackable Hubs User's Guide
Port Speed. This field displays the port
(100M or 10M) relative to the speed of the device connected to it.
Speed Capability. This field displays the port
ting, Auto for auto-detect/correct, 100M for 100Mbps connections
only, or 10M for 10Mbps connections only. This variable is user con-
figurable.
DFE-2600 Stackable Hub - Network Monitoring : Port State Menu
Group ID(1-8) [1]
Connector Type: UTP
Port Status
Link Test:
Receive Polarity: Normal
Auto Partition:
Port Speed:
PREV GROUP NEXT GROUP
You can use PREV GROUP and NEXT GROUP to switch to another hub,
or PREV PORT and NEXT PORT to switch to another port. You can also
enter the port Group ID and Port ID numbers to go directly to a different
port.

Monitoring the Hub Stack

The hub supports several monitoring functions, allowing you to keep statis-
tics on the operation of each port, each hub, and the entire network segment,
as well as to monitor the addresses of the packets received at each port.
60
Port ID(1-24) [1 ]

Port State

Up Link Test State:
On Admin State:
100M Speed Capability: <Auto
PREV PORT NEXT PORT
Master Hub Setup and Management
current operating speed
current speed set-
<Enable >
<Enable >
>
HELP SAVE EXIT